Digico DiGiGrid MGB/MGO User Manual download pdf

DiGiGrid MGB/MGO Quick Setup Guide

Registration

You must register your DiGiGrid MGB/MGO to get the software, drivers and any licenses needed.

To register your device, log into your Waves account at www.waves.com

Software Download

Go to Waves.com > Downloads > Hardware Drivers

and select either MGB or MGO.

Download the latest version for Mac or PC, as needed.

Run the installer and follow the onscreen instructions.

Connections

Connect your MGB/MGO to your computer.

If you are using one MGB/MGO, connect it directly to your computer’s Gigabit Ethernet port using the

supplied cable.

If you are using multiple interfaces—two MGB/MGOs, an MGB/MGO with an additional SoundGrid

interface, an MGB/MGO with multiple computers, etc.—connect them all to a SoundGrid-compatible

switch, and connect the switch to your computer’s Ethernet port.

See http://www.waves.com/hardware/soundgrid-switches

for a list of approved switches.

Simple Recording/Playback Setup with the SoundGrid Studio Application

Use the SoundGrid Studio Application as your setup application. Refer to the following images for

configuration.

1 2 3

1 DiGiGrid MGB/MGO Quick Setup Guide Registration You must reg

Page 2

2 Note: The first time you run and configure your MGB/MGO, you may be prompted to update the firmware of your device. Follow the onscreen instruction

Page 3

3 Setting Up Recording/Playback with MultiRack SoundGrid If you are using the SoundGrid Studio Application together with MultiRack SoundGrid, set th

No comments

Digico DiGiGrid MGB/MGO User Manual